The 416 Standard Camera Handle can be extended with
the Handle Extension Block HEB-1 aphoto. The Handle
Extension Block can be mounted to any of the 3/8-16 holes
by rst placing the 2 pins aphoto into the corresponding
pin holes on the handle and then fastening the extension
block screw aphoto inside the extension block by using
a long 5mm Allen key. Note that the viewnder cannot be
swung over to the camera right side when the Handle
Extension Block is attached to the front of the 416
Standard Camera Handle.
Note: The 416 Standard Camera Handle is positioned
in the centre of gravity for a typical conguration.
416 Riser
A at base with diverse attachment points for use when
attaching the 416 to a Steadicam plate or other at surface.
Useful when working with Lightweight Support LWS-5, in
order to have LWS-5 clear the mounting surface. Useful
since 416 bottom threads are not compatible with some
Steadicam plates. Also useful in situations requiring
additional mounting security.
Intallation
handle extension block HEB-1
block screw
pins
