Note: The automatic image compensation locks in two
positions 180° apart. This allows the image
compensation to be set to provide an upright
image when using a nder extension.
If the viewnder image is inverted without the nder
extension, the image compensation must be adjusted to
the opposite locking position.
Inverting the Image
• Press the locking button aphoto and keep pressed.
• Turn the adjustment knob aphoto.
• Release the locking button aphoto.
• Keep turning the adjustment knob aphoto until the
locking button pops up and the adjustment knob locks
in position.
Removing the Viewnder System
Before removing the viewnder system, the viewnder
arm should be brought back to its normal position.
• Loosen the three fastening screws aphoto.
• Pull the viewnder system up and off the camera body.
• If the camera is to be used without the viewnder, t
the cover to protect the beamsplitter prism.
Attaching the Viewnder System
• Position the viewnder system on the camera body
from above.
• Tighten the fastening screws.
Viewnder Warnings
A LED glows when the camera is not running at the set
speed (ASY). This LED blinks when the battery voltage is
low (BAT).
Optic
screws
locking button
adjustment knob
