Installation Guide P. 29
OEM-Style Alarm
The OEM-style alarm (if configured) monitors the doors, hood and ignition switch of the vehicle. It
will sound the horn if a door or the hood is opened, or if the key is turned in the ignition (the horn
option must be enabled and one of the door inputs must be connected).
• To arm the OEM-style alarm, press the LOCK button on the transmitter.
- The OEM-style alarm will ONLY arm if the LOCK button on the transmitter is pressed.
- The LED on the antenna will flash slowly to indicate that the OEM-style alarm is now
armed.
• To disarm the OEM-style alarm, press the UNLOCK button on the transmitter.
- To stop the horn from sounding if the OEM-style alarm is triggered, press the LOCK or
UNLOCK button, or put the system in and out of Valet Mode.
Ready Mode Option
If the vehicle has a manual transmission, please read the following indications. In order to start
the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready
Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake, depending on
the option that was selected. Therefore, you must follow the appropriate procedure between
the two described below in order to set the vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at any time.
The system will exit Ready Mode if a door, the hood or the trunk is opened, if the brake pedal is
pressed, if the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN)
position.
To set the system to Ready Mode:
If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake
1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the
neutral position.
2. With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
2. With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
3. Within 20 sec. of engaging the parking
brake, press and hold LOCK, UNLOCK or
START/STOP on the transmitter.
The parking lights will flash 3 times
quickly and remain lit.
-
4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press for approx. 1 second either:
a. LOCK to lock the doors and shut down the engine;
b. UNLOCK to unlock the doors and shut down the engine;
c. START/STOP to shut down the engine without affecting the doors.
Note: The vehicle will also enter Ready Mode once the engine run time expires.
Bypass
Remote starters of this series offer three possibilities for bypass D2D: they are compatible with
Trilogix, ADS and Fortin bypasses (Trilogix by default).
