P. 30 Installation Guide
Vehicle Status Request
The status request feature allows the user to see the status of the vehicle i.e.: if the doors are
locked or unlocked or if the vehicle is in cold weather mode, home valet mode, valet mode or how
much time is left in the run time cycle. The following charts (Tables 1, 2 and 3) indicate the
confirmation sequences.
To retrieve the vehicle status:
Press and release the AUX button then press and release the TRUNK button (there will be a beep).
The transmitter will then flash the corresponding sequence of LEDs, depending on the vehicle’s
status.
x If the engine is NOT running, refer to Table 1.
x If the vehicle is in or out of ready mode, refer to Table 2.
x If the engine IS running under a remote start, refer to Table 3.
The status request feature is a two-step procedure:
• The first sequence of flashes denotes if the vehicle’s doors are locked or unlocked.
• The second sequence of flashes (if applicable) denotes if the vehicle is in Cold weather mode,
Home valet mode, or Valet mode.
• If there is no second-sequence transmission, then the vehicle is in none of the three (3)
mentioned features (Cold weather mode, Home valet mode or Valet mode).
Status Request When the Engine IS NOT Running
STATUS SEQUENCE LED #1 LED #2 LED #3 LED #4 Beep(s)
Lock 3 flashes X X X 1
Unlock X 3 flashes X X 2
1
st
sequence if
locked
3 flashes X X X 2
1
st
sequence if
unlocked
X 3 flashes X X 2
Cold
Weather
2
nd
sequence X X X 1 second X
1
st
sequence if
locked
3 flashes X X X 2
1
st
sequence if
unlocked
X 3 flashes X X 2
Home
Valet
2
nd
sequence 1 second X X 1 second X
1
st
sequence if
locked
3 flashes X X X 1
1
st
sequence if
unlocked
X 3 flashes X X 1
Valet
Mode
2
nd
sequence 1 second X X 1 second X
Table 1
Ready Mode Status Request
STATUS SEQUENCE LED #1 LED #2 LED #3 LED #4 Beep(s)
if locked
3 flashes X X X 1
In Ready
Mode
if unlocked
X 3 flashes X X 2
Out of Ready
Mode
1
st
sequence
if locked
3 flashes X X X 1
