Chapter 4: Connecting D-Command 19
Audio Connections
D-Command monitoring is based on the XMON analog interface, which is remotely controlled from the D-Command monitor-
ing section. All external analog audio inputs and outputs for control room monitoring and studio communication are connected
to the XMON interface.
XMON provides 18V phantom for its three external mic inputs (External Talkback Mic, Listen Mic 1, Listen Mic 2).
All audio connections are made with standard DB-25 connectors. The back panel of the XMON is shown in Figure 6.
XMON Monitoring System Connection
D-Command connects to XMON with a single 15-pin XMON cable. A 50-foot (15.25 m) cable is included with the D-Command
Main Unit. The system supports up to an 80-foot (24.5 m) cable.
To connect the XMON to D-Command:
1 Connect the included AC power cord to the back panel of the XMON and to a power source. A surge protected power source
is highly recommended.
2 Connect one end of the included XMON cable to the Control Surface port on your XMON unit, and the other end to the 15-pin
XMON Monitoring System connector on the back panel of the D-Command Unit.
Figure 6. XMON back panel
Cue Inputs
Cue Outputs
Main Inputs Surround Inputs Stereo Inputs
Main Outputs Alt Outputs Talkback/ Meter Calibration Control Surface AC Power
Listenback/
Utility
Screws
