A SERVICE OF

logo

CAUTION: If you are permanently removing the sled, install a sled blank. Operating the
enclosure for extended periods of time without a sled blank installed can cause the enclosure
to overheat.
2. Lift the sled release latches upward by 90 degrees, and holding it by the latches, pull the sled out of
the enclosure.
CAUTION: To protect the I/O connector pins, install the I/O connector cover every time a
sled is removed from the enclosure.
3. Install the I/O connector cover over the I/O connectors.
Figure 16. Removing a storage sled
1. sled lock (2) 2. dotted line on storage sled
3. sled release latch (2)
19