Chapter 4: Web Configuration
75
Bridging
If the mode you choose is Bridging (or MER), please refer to the following
information.
The bridging mode can configure your
router to send and receive packets
between LAN and WAN interfaces.
The WAN interface is ATM PVC; the
LAN interface can be Ethernet, USB,
or Wireless.
Choose Bridging and click Next.
None:
If it is not necessary to set the WAN IP
address, please click this button. In
our example, we select this item.
Obtain an IP address automatically:
Click this button to allow the system to
get an IP address automatically.
WAN IP Address, WAN Subnet
Mask, and Default Gateway:
When choosing Use the following IP
address, you have to key in the IP
address, the subnet mask, and the
default gateway provided by your ISP
for the WAN interface.
While you choose to obtain the IP
address automatically or use specific
IP address, you have to decide
whether to select Obtain DNS server
address automatically or Use the
following DNS server address and
enter the information provided by you
ISP.
Check Enable NAT if necessary.
Press Next to continue.
The default setting is none, while
selecting Obtain an IP address
automatically or Use the following
IP address, the DNS setting appears,
shown as the figure below.
Primary IP Address & Subnet Mask:
Key in the IP address and the subnet
mask that provided by your ISP for
LAN interface, e.g., 192.168.1.1 and
255.255.255.0, respectively.
MTU: Please refer to PPPoA/ PPPoE.
DHCP Server On:
Check this item if DHCP service is
needed on the LAN. The router will
assign IP address and gateway
address for each of your PCs. Enter
the information for Start IP, End IP
and Lease Time if you enable this
function. The default value for lease
time is one day.
DHCP Server Off:
Check this item if DHCP service is not
needed on the LAN; like our example.
