If you have never set the real-time clock, the entry at the top of
the screen flashes to remind you to set the time and date. See
“Setting the Real-time Clock,” above, for instructions.
To view the last Setup summary screen, press PgDn. You see
your hard disk drive configuration(s):
Hard disk drive
Drive 1:
Type
17
Number of cylinders
977
Number of heads
5
Number of sectors
17
Precomp. cylinder
300
Landing
zone
977
Total capacity (MB)
40.5
,
Drive 2: None
Number of cylinders 0
Number of heads
0
Number of sectors
0
Precomp.
cylinder
0
Landing zone
0
Total capacity (MB) .0
Check each Setup summary screen to see if all the information
is correct. You can press PgUp to display the previous screen or
PgDn to display the next screen.
If anything is incorrect, be sure Change settings is
highlighted and press Enter. The main Setup menu appears and
you can change the appropriate settings.
Leaving the Setup Menu
If you did not change any settings or you want to cancel the
changes you made, highlight Exit without saving
at a Setup summary screen and press Enter. The Operation
Menu appears. Press 0 and Enter to exit. (If you changed the
time or date, the new setting takes effect even if you exit the
Setup program without saving your changes.)
Running the Setup Program
2-31
