12
Install the SCSI Interface Board
You must install your SCSI board before installing the scanner driver and software
applications.
If you have a Macintosh with a SCSI interface, or if you already have a SCSI board
installed in your PC, skip this section.
For additional installation information, see your computer
documentation.
1. Turn off the computer and any peripheral devices. Unplug any power cords; then
disconnect all cables from the back panel of your computer.
2. Remove the cover from your computer (or open up your Macintosh G3).
Static electricity can damage
electronic components.
Ground yourself before you
touch any of the computer’s
internal components by
touching an unpainted metal
surface inside the computer
case.
3. Remove the slot cover from an empty PCI
expansion slot in your computer. (Refer to
your computer documentation for
information about your PCI slots.)
4. Insert the interface board into the slot; then
secure it with the bracket screw.
5. Replace the computer cover and reconnect
all cables.
6. Continue with the following section, “Unlock the Scanner.”
