The projector is recognized as a removable disk by the computer.
d
Copy the batch setup file (PJCONFDATA.bin) that you saved to
your computer to the toplevel folder of the removable disk.
a
Do not copy any files or folders other than the batch setup file
to the removable disk.
e
Perform "Remove USB Device" on your computer, and then
disconnect the USB cable.
a
When using OS X, perform "Remove EPSON_PJ".
When all of the indicators start flashing, the settings are being
written.
Caution
Do not disconnect the power cord from the projector while the settings
are being written. If the power cord is disconnected, the projector may
not start correctly.
When writing completes normally, the projector turns off, and only the
power indicator is lit blue.
When Setup Fails
Check Remedy
Are the lamp indicator and the
temperature indicator flashing orange
quickly?
The batch setup file may be corrupt, or the
USB storage device or USB cable may not
be connected correctly. Disconnect the
USB storage device or USB cable, unplug
and then plug in the projector's power
cord, and then try again.
Are the power indicator and the status
indicator flashing blue quickly, and the
lamp indicator and the temperature
indicator flashing orange quickly?
Writing the settings may have failed and
an error may have occurred in the
projector's firmware. Stop using the
projector, remove the power plug from
the electrical outlet, and contact your local
dealer or the nearest address provided in
the Epson Projector Contact List.
Performing Batch Setup for Multiple Projectors
140
