Saving a User's Logo
You can save the image that is currently being projected as a User's Logo.
You can use the registered user's logo as a display when projection starts or
no image signal is being input.
s Extended - Display p.120
a
• Once a User's Logo has been saved, the logo cannot be returned to
the factory default.
• If the content of the Configuration menu is set from another
projector using the batch setup function, the registered User's Logo
is set for the other projectors. Do not register confidential
information and so on as the User's Logo.
s
"Performing Batch Setup for Multiple Projectors" p.136
a
Project the image you want to save as the User's Logo, and then
press the [Menu] button.
s "Using the Configuration Menu" p.113
Using the remote control Using the control panel
b
Select User's Logo from Extended.
a
• When User's Logo Protection from Password Protection is
set to On, a message is displayed and the User's Logo cannot
be changed. You can make changes after setting User's Logo
Protection to Off.
s "Managing Users (Password Protection)" p.98
• If User's Logo is selected when Keystone, E-Zoom, Aspect, or
Adjust Zoom are being performed, the function currently
being performed is temporarily cancelled.
c
When the message "Choose this image as the User's Logo?" is
displayed, select Yes.
a
When you press the [Enter] button on the remote control or
the control panel, the screen size may change depending on the
signal to match the actual resolution of the image signal.
Projection Functions
95
