50
Fine-tuning the Projector
6. When you see the message “Do you use this image?” select
Yes
and press
Enter
. If you want to change the area selected, select
No
, press
Enter
and repeat steps 4 through 6. You see the message
shown at the left.
7. Use the arrow buttons on the control panel or the
Enter
button
on the remote control to select a zoom rate (display size), and then
press
Enter
.
8. When the message “Do you save this image?” appears, select
Yes
and press
Enter
.
Saving the logo may take a few moments. Do not use the
projector or other sources (computer, video, speaker, etc.) while
the logo is being saved.
9. When you see the message “Saving the user logo is completed,”
press the
Menu
or
Enter
button to return to the Capture menu.
Then press
Esc
to return to the main menu.
Setting Up When the Image Displays
After your image is saved, you can set it up as the no-signal message
and/or the screen that’s displayed when you press the
A/V Mute
button.
1. Press the
Menu
button to display the main menu (if not already
displayed).
2. Press the down arrow (control panel) or press down on the
Enter
button (remote control) to highlight the
Setting
menu.
3. Press the
Enter
button to select the Setting menu.
4. Press the down arrow (control panel) or press down on the
Enter
button (remote control) to highlight
No-Signal Msg
.
5. Press the right arrow or use the
Enter
button to select
Logo
. This
sets your image as the screen displayed when the projector is not
receiving a signal.
6. If you want to set up your image as the A/V Mute display, use the
down arrow or
Enter
button move down to
A/V Mute
.
note
You can also set up your
image as a startup screen. Use
the Advanced menu to enable
the startup screen; see
age 53.
7700.book Page 50 Wednesday, November 1, 2000 6:15 PM
