60
Maintaining and Transporting the Projector
4. If you need to replace the filter, pull on the catch to remove it.
Make sure the projector is on its side as shown (not turned upside
down) to prevent dust from falling inside.
5. To install the new filter, first insert the tabs, then press on the
catch until it clicks in place.
Replacing the Lamp
The projection lamp typically lasts for about 1500 hours of use. It is
time to replace the lamp when:
■
The projection image gets darker or starts to deteriorate.
■
The lamp warning light is flashing red or orange.
■
The message
LAMP REPLACE
appears on the screen when the
projector lamp comes on (after about 1400 hours of use). To
maintain projector brightness and image quality, replace the lamp
as soon as possible.
Contact your dealer or call EPSON at (800) 873-7766 in the United
States and Canada for a replacement lamp. Request part number
ELPLP12
.
tabs
note
You can check to see how
many hours the lamp has
been used. See page 54.
7700.book Page 60 Wednesday, November 1, 2000 6:15 PM
