A SERVICE OF

logo

A-2
A-2 | Installing an Interface Card
2. Use a Phillips-head (+) screwdriver to remove the two screws securing
the shield plate to the back of the printer. Then lift off the plate.
Be sure to keep the screws so you can use them if you re-install the shield
plate.
3. Make sure you set any jumpers or DIP switches on the card. See the
card’s documentation for details.
On the FireWire card, make sure DIP switch 10 is set to
ON
(advanced
mode).
4. Slide the interface card along the slots on both sides of the
compartment. Push it in firmly to fully insert the connector into the
printer’s internal socket.