![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/b/24/b246733e-37db-4b55-9ede-f6a1f78e590d/b246733e-37db-4b55-9ede-f6a1f78e590d-bg1a.png)
(4) Removal of shipping screws
The purpose of the shipping screws is to protect the MX-80 F/T Type I I against
any damage that may be caused by shocks or vibrations during transportation.
Therefore, before operating the MX-80 F/T Type II, remove the screws as
described below. (See Fig. 22.1
STEP 1.
Stand the printer on its left side.
STEP 2.
Remove with a screwdriver, the two shipping screws visible on the
underside of the lower case.
Right Side of the Printer
NOTE: Save the two shipping screws for possible future use.
< SUPPLEMENT >
• If the printer lid is an obstacle when removing the shipping screws, be sure to
take off the printer lid by observing the following steps. Rough or careless handling
of the printer lid may result in damage to, or even breakage of, its hinges.
-20-