GPSMAP 3205 Owner’s Manual 19
basIc oPeratIon > navIgatIng to a destInatIon
To add a proximity waypoint:
1. Press the New Alarm soft key on the Proximity sub tab. The Find From
Current Position Page appears.
2. Highlight a category, and press ENTER.
3. Use the ROCKER to highlight a waypoint or map item from the list, and
press ENTER. The Review Page appears for the selected waypoint or
map item within a red circle.
4. Press the OK soft key. The Proximity sub tab appears with the Distance
highlighted.
5. Press ENTER to begin entry of the proximity radius.
6. Use the ROCKER to enter a distance (up to 99.99 units), and press
ENTER when nished.
To turn proximity alarms on or off:
1. Use the ROCKER to highlight the eld below Proximity Alarm on the
Proximity sub tab, and press ENTER.
2. Select ON or OFF, and press ENTER.
To clear one or all proximity waypoints from the list:
1. Use the ROCKER to highlight the proximity waypoint you want to clear.
2. To clear a single alarm, press the Delete, soft key.
OR
To clear all proximity waypoints, press the Delete All soft key. A
conrmation message appears.
3. Press the OK soft key to delete the proximity waypoint. Otherwise, press
the Cancel soft key, or press QUIT to cancel.
Navigating to a Destination
Using the NAV key, the GPSMAP 3205 provides four ways to navigate to a
destination—Go To Point, Follow Track, TracBack, and Follow Route. When you
are actively navigating, you see a straight line that always runs from your current
location to the destination on the Map Page. The easiest method for selecting a
destination is the Go To function, which allows you to select a destination point,
and then quickly sets a direct course from your present location. If you highlight
a point on a list or the map and press NAV, Go To <point name> appears in
addition to Go To Point. The Go To function can be accessed from any list of
points or graphically from the map display.
Destination
Current location
Navigating to a Destination
