A SERVICE OF

logo

Open as PDF
next previous
Removal and Replacement Procedures98
PCI Card Support
For added protection, some cards have PCI holders installed to prevent movement during shipping.
To remove the card support:
1. Disconnect power from the system (page 79) and remove the access panel (page 86).
2. For short or tall PCI cards, lift up on the holder arm
1 with one hand and press in on the sides 2 of
the holder and rotate it
3 out of the chassis.
To install card support:
1. Disconnect power from the system (page 79) and remove the access panel (page 86).
2. For short or tall PCI cards, attach the lips of the support arm
1 under the slots on the rear of the
chassis, then rotate the card support down until the black part of the arm
2 supports the card.