A SERVICE OF

logo

Open as PDF
next previous
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
26
SEC
2” x 6” x 117”X
2” x 4” x 123 1/2”X
vXvX,EVELING"OARDX
8d 1 1/2” Common Nail (x16) Pea Gravel#UBIC&EET
L-Bracket (x4)
1
ALTERNATIVE SITE PREPARATION: OPTION 2 - FILLED WOOD FRAME ASSEMBLY
Note: Whenever possible you should use the surfaces described on Page 7.
!
Note: All lumber must be rated for outdoor use.
!
SEC
1.5
SEC
1.6
SEC
1.7
#UTOUTSIDEFRAMETOvBYvOUTSIDEDIMENSIONS,AYBOARDSmATSOWIDESTPARTFACESUP
Ensure frame is level. Square up the frame by measuring from corner to corner. Measurement A should equal
Measurement B. Nail an L-Bracket on each corner of the frame with 8d nails. Place platform in the desired
LOCATION)FPLATFORMDOESNOTRESTLEVELONTHEGROUNDBUILDUPLOWPOINTSWITHLOOSEDIRTORh0EAvGRAVELUNTIL
platform is stable.
Once all boards are level and do not wobble,
PACKh0EAvGRAVELAROUNDTHEOUTSIDEOFTHE
frame, and slope away from frame.
.OWlLLTHEINSIDEOFTHEFRAMEWITHh0EAv
gravel. Use a leveling board to scrape off extra
fill material and to level the surface.
2” x 6” Boards
123 1/2”
123 1/2”
B
A