29
6.11 Pressure Adjuster Rebuild Kit
Part No. 986471
INSTALLATION INSTRUCTIONS:
1. USING A 1" END WRENCH, REMOVE THE PRESSURE ADJUSTER FROM TANK. THIS IS
BEST DONE WHEN THE UNIT IS WARM, BUT NOT HOT!
2. BE SURE THAT ALL PARTS ARE REMOVED FROM THE TANK.
3. USING A 3/32 ALLEN KEY, REMOVE THE SET SCREW FROM THE ADJUSTING KNOB AND
UNSCREW THE KNOB FROM THE SHAFT.
4. USING A PAIR OF PLIERS, GRASP THEUNTHREADED END OF THE PRESSURE ADJUSTER
SHAFT AND REMOVE BY TURNING IN A COUNTER CLOCKWISE DIRECTION UNTIL
THREADS ARE DISENGAGED FROM BODY.
5. USING A SMALL SCREWDRIVER OR AN AWL, REMOVE THE SEAL FROM THE BODY AND
ALSO THE O-RING # 2-018.
6. USING THE CLEANING SOLUTION PROVIDED AND THE CLEANING PAD, CLEAR ALL THE
SURFACES OF THE BODY, ESPECIALLY THE SEAL SURFACES.
7. USING THE LUBRICANT PROVIDED, APPLY TO INSIDE OF BODY (SMALL OPENING) FROM
THE SEAL END. APPLY A SMALL AMOUNT TO THE ORINGS, TO THE THREADS ON THE
SHAFT AND TO THE UNTHREADED PORTION OF THE SHAFT.
8. PRIOR TO ASSEMBLY, LUBRICATE O-RINGS AND SEAL (SUPPLIED), REPLACE O-RING # 2-
018 OVER THE BODY, REPLACE SEAL INTO THE BODY WITH OPEN SIDE OF THE SEAL
FACING OUTWARD AND THE O-RING # 2-010 TO THE SHAFT.
9. INSERT PRESSURE ADJUSTER SHAFT INTO BODY USING CARE NOT TO PUT THE
THREADS OF THE SHAFT INTO CONTACT WITH THE SEAL.
10. SCREW THE SHAFT INTO THE BODY UNTIL IT STOPS AND REPLACE THE KNOB AND SET
SCREW USING CARE TO ENSURE THE SET SCREW IS TIGHTENED ONTO THE FLAT OF THE
SHAFT.
11. REINSTALL THE ASSEMBLY BACK INTO THE TANK USING THE NEW SPRING PROVIDED
AND ENSURE THAT THE ASSEMBLY IS TIGHT.
Needle, Pressure Adj.
O-Ring 2-010
O-Ring 2-018
Spring
Seal
