31
6.14 Tank Thermistor Assembly Replacement Bulk-14
Part No. 986467
Installation Instructions:
Note : Disconnect power form unit.
1. REMOVE 2 SCREWS FROM BOTTOM LIP OF THE PANEL AND TILT FORWARD.
2. DISCONNECT GROUND WIRE AND CONNECTORS AND SET ASIDE.
3. REMOVE FROM UNDER THE LIP OF THE FRAME, THE FOUR (4) SCREWS USED TO SECURE THE
ENCLOSURE TO THE FRAME.
4. LIFT ENCLOSURE FROM FRAME AND SET ASIDE.
5. FROM THE FRONT OF THE UNIT, CUT THE METAL TAPE ON THE SIDES OF THE TANK
INSULATION IN ORDER TO LIFT UP THE BOTTOM OF THE FRONT SECTION.
6. DISCONNECT THE TANK THERMISTOR WIRES
7. REMOVE THE THERMISTOR. USING A 5/8” WRENCH, SLIDE THERMISTOR WIRES THROUGH
WRENCH AND PLACE WRENCH AROUND RETAINING NUT. LOOSEN AND REMOVE
THERMISTOR ASSEMBLY (#1, 2, 3). INSPECT AND REPLACE IF REQUIRED.
8. INSTALL THE NEW THERMISTOR IN REVERSE ORDER.
9. RETAPE THE INSULATION. REPLACE THE COVER AND FRONT PANEL.
Tank Heaters
Tank Front Ref.
1
2
3
