MS9400 HD FrEND User Guide Chapter 2: Player Controls and Set-Up
18 Rev. 1.50
“Quick Start”
Assuming correct connection of the MS9400 into a display system, perform system steps 1-3 below to turn on the
player and play a test file:
1. Turn on the main POWER OFF/ON switch at the rear of the player (the power LED on the front panel
will glow). NOTE: Should the power Led not illuminate, toggle the power switch between OFF/ON.
2. The Hard Drive Led will flash whilst the MS9400 is completing its initialization. This could take up to 30
seconds. Once the hard drive Led has stopped flashing the unit is ready to play a file.
3.
Press the <MENU> button on the remote control (having first, pressed the <PC> button). The on
-screen menu appears:
This default menu is the Clips menu.
Some test files are pre-loaded on the MS9400; you may play a Test File if desired.
To play a Test File:
• Use the joystick to navigate to the desired file. Press <SELECT> on your hand-held remote control; the
file will be highlighted.
• Navigate to and Click <Play> on the menu; the chosen file will begin loop-play until it receives a stop
command
• Press the <STOP> button on your hand-held remote control. The player display will go black.
• Press <MENU> to return to the main menu
Refer to Chapter 4: Playing Files for more information
