Using the remote control to operate cable boxes
and other brands of VCRs
operating Mitsubishi components
This TV's remote control comes programmed to op_rate Mitsubishi
TVs and VCRs. The select buttons (across the top of the remote
control) determine which component the remote control will
operate.
The following buttons are available
• power button
• pause button
• mute control
• super quick view button
• quick view button
• volume control
• input button
• channel control
• enter button
• audio and video controls
when using this TV:
• menu button
• cancel button
• display button
• home button
• off-timer button
• number buttons
• PIP controls
• VCR buttons
• quick prograln button
operating cable boxes or VCRs from other manufacturers
The remote control is pre-set to operate Mitsubishi VCRs, but it
can also operate VCRs from other manufacturers as well. If you
have a VCR from another manufacturer, or if you have a cable box,
you should "set up" the remote control.
Each layer on the remote control (CABLE, VCR-A, or VCR-B) can
be set for either a cable box or a VCR.
setting up the remote control to operate your VCR
O Turn off your VCR.
O Press one of the select buttons across the top of the remote
control to choose the layer that you want to "set up." You can
choose between VCR-A, VCR-B, or CABLE.
O
While holding in tbe POWER button on the remote control,
enter the code number listed in the chart on the following page
for your brand of VCR. Be sure to enter both digits of the code
number. If more than one number is listed, try the first one.
Release the POWER button.
O Press the POWER button again. Your VCR should turn on. If
the VCR turns on, your remote control is now set to operate
your VCR.
44 Chapter 3: Operating Your TV
