Transmission Fluid Exchanger
55
55
5
Initial Setup
Accessory Kit
Unpack Accessory Kit located inside the rear door
of unit. Accessory Kit includes: Adapter set,
warranty card, and hose hanger bracket.
Attach Hose Hanger Bracket
1.
Drop tube all the way down over existing tube
on unit.
2. Rotate to align holes.
3. Insert screw into the middle hole.
Registering the Unit
To validate the warranty provided by SPX
ROBINAIR, complete the warranty card included
in the accessory kit, and mail it within ten days
from the date of purchase.
WARNING
This manual contains important procedures concerning the setup, operation, and
maintenance of the unit. Study and follow all warnings at the beginning of this manual. Do
not operate the unit until you have read and understand the contents of this manual. If you
do not understand any of the contents of this manual, notify your supervisor. If the operator
cannot read English, all instructions and safety precautions must be read and discussed in the
operator’s native language.
Application Notes
Ford Taurus with a 3.0 liter V6 requires the
removal of the vent cap located behind the
shifter linkage on top of transmission before
service. This will minimize “overfilling” due to
lack of headroom in the transmission housing.
Low pressure transmissions require the
transmission be left in neutral with the parking
brake secured during the “dynamic” (engine
running) phase of the ATF service.
Import vehicles, with small dipstick tube
openings, require the 529740 flexible nylon
hose, which has a smaller blue section at the
end, in place of the 529734 hose.
Helpful Tips
To avoid oil spillage, turn unit on before removing
the flexible nylon hose from its storage area.
Press the Pause/Abort once to pause an opera-
tion; press ENTER to continue the operation.
Press and hold the Pause/Abort button to
discontinue an operation and to reset the unit.
For the quickest and most accurate exchange,
ensure transmission is warmed to normal
operating temperatures.
IMPORTANT: To prevent damage to the
vehicle, ensure all hoses are correctly
connected before transferring fluid.
Hose Hanger Bracket
Align holes
Nylon Hose
Storage
