Transmission Fluid Exchanger
77
77
7
Operating Procedures
Dipstick Only Mode
continued
When the selection in step 8 is met, the buzzer
sounds and the
End Service
and ENTER LEDs
light.
4. Press ENTER to confirm that the correct
amount of ATF has been replaced.
Check
Trans Level
LED lights.
Check the ATF Level in the Pan
1. Remove the flexible nylon hose.
2. Insert the dipstick.
3. Remove dipstick to check level of fluid.
If the fluid level needs to be adjusted, continue
on to “Adjust the ATF Level.” If the level is
satisfactory, go to step 4 under “Adjust the ATF
Level.”
Adjust the ATF Level
1. Place the flexible nylon hose in the dipstick
tube.
2. Press ENTER. The
To Trans
,
From Trans
and
Finish
LEDs light.
a. If the level is too low, select
To Trans
LED. Press ENTER. Press the up arrow key
to select how much fluid to add (each press
indicates one-tenth of a quart).
b. If the level is too high, select
From Trans
LED. Press ENTER. Press the up arrow key
to select how much fluid to take out (each
press indicates one-tenth of a quart).
3. When transfer is complete, go to “Check the
ATF Level in the Pan.”
4. If the level is satisfactory, press SELECT
until
Finish
LED lights.
a. Wait for one second.
b. Press ENTER to confirm the function.
c. Press ENTER again.
The display reads SR FIN, indicating the service
is finished.
