English
42
Settings/
Adjustments
Specifying Alarm Input
M
MM
M
Select “ZOOM” and specify the zoom factor for
alarm detection.
• Select from: OFF (no zoom), x 1.4, x 2.0, x 2.5.
N
NN
N
Select “ZOOM TIME” and specify duration time
for zooming (if you specified “ZOOM” to other
than “OFF” in step M).
• Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M
(S = second, M = minute)
O
OO
O
Select “DURATION” and specify a time until the
next alarm input becomes enabled.
• Select from: 5S, 10S, 15S, 20S, 30S, 1M, 2M, 3M, 4M or 5M
(S = second, M = minute)
P
PP
P
Set “MENU” to “END” and press the SET button.
RFinishes the settings screen and returns to the normal
monitoring screen.
• If you want to return to the previous screen, select “BACK” and
press the SET button.
Note: • If you specify the “ZOOM” function, the center of the
screen will be electronically zoomed in automatically
when an alarm signal is supplied from external devices
such as door switch or infrared sensor, etc.
• Even though the “EL ZOOM” is already specified, the
“ZOOM” settings you configure here will override it. Then
“EL ZOOM” will be set to “OFF”. (See page 54)
• When “ZOOM” is set to “ON”, the detection zone of the
motion sensor is limited to CENTER (initial position and
size). When switching “ZOOM” back to “OFF”, the above
setting will revert to those specified before “ZOOM” was
set to “ON”. Also note that no adjustment is possible for
“BLC” – “CENT” if “ZOOM” is set to “ON”. (See page 23)
• If “BLC” has been set to “CENT”, the “ZOOM” function
will not work. (See page 22)
MOTION SET SET
ZOOM
ZOOM TIME
DURATION 5S
5S
ALARM IN SETTING
MODE ALM
POLARITY NO
MOTION OFF
PRESET OFF
MENU BACK
OFF
Note: • When the “MODE” is specified with “COLOR”, this
setting will not appear.
• When the alarm output starts, a new detection or an
alarm output cannot be performed until the specified
time of duration elapses.
MEMO: You can blink the camera name on the screen when an
alarm signal is supplied. (See page 45)
