Chapter 6 Configuring the Preinstalled OpenSolaris Operating System 83
10. Press Esc to exit the Configuration utility.
11. Reboot the OpenSolaris OS.
Mirroring the Preinstalled OpenSolaris
OS With Sun StorageTek HBA Card
The Sun StorageTek host bus adapter (HBA) card enables you to choose from many
RAID configurations. How you configure your system depends on your system
requirements and the available hard disk drives in the system.
This procedure describes how to mirror the preinstalled OpenSolaris OS. This is the
better option, and all remaining disks (should there be more than two) are
incorporated into a DATA RAID set using the available options as shown in
TABLE 6-3.
You will need the Sun Blade X6270 Server Module Tools & Drivers CD.
▼ Create a Mirror Image of the Preinstalled
OpenSolaris OS With Sun StorageTek HBA Card
Follow these steps to mirror your configured OpenSolaris OS:
1. Using your OpenSolaris server, log in and start Xserver.
This graphical user interface is required for StorageTek Software Management.
2. Make a new directory on your OpenSolaris server, type:
mkdir /StorMan
3. Insert the supplied Tools & Drivers CD, and copy the StorMan.dss application,
located in the /mount-point/RAIDmgmt/StorageTEK/OpenSolaris
directory, to the new directory you created on your OpenSolaris server, for
example,
/StorMan.
4. Change the permissions of the new directory and StorMan application, type:
chmod 777 StormMan.pkg
5. Run the following command to install the application, type:
pkgadd -d StorMan.pkg
6. Choose to install all components when prompted.
