Greensmaster 1000/1600Page 7 – 14Cutting Unit
Bedbar
Removal
1. Position mower on a flat level work surface. Make
sure engine is OFF. Remove high tension lead from the
spark plug.
2. Loosen jam nut on the adjusting screw. Loosen ad-
justing screw until the thrust washer contacts the inside
of the frame adjuster. Accomplish on both sides of the
mower (Fig. 21).
Use caution when removing the bedbar. Ad-
justing screw springs (Fig. 22) are under ten-
sion and could release suddenly.
WARNING
3. Compress spring with a pair of channel lock pliers.
Insert a pin to hold the spring in position (Fig. 22).
4. Loosen flange nuts on both sides of the mower. Re-
move both bedbar bolts on each side of the mower with
the metal and nylon washers. Discard nylon washer
(Fig. 23).
5. Remove bedbar from the mower. Keep metal wash-
ers and discard nylon washers. Remove and discard
both nylon bushings (Fig. 24).
1. Jam nut
2. Adjusting screw
3. Thrust washer
4. Frame adjuster
Figure 21
1
2
3
4
1. Spring 2. Pin (Allen wrench)
Figure 22
2
1
1. Flange nut
2. Bedbar bolt
3. Metal washer
4. Nylon washer
Figure 23
4
3
2
1
1. Bedbar 2. Nylon bushing
Figure 24
1
2
