Programming the Machine
2-36 WorkCentre Pro 555/575
Setting the Machine Default Settings
Error Correct - ECM Default Setting
Error Correction Mode (ECM) is an internationally-recognized error
correction system. It enables communications with clean images
since it automatically re-sends any portion of the document affected
by line noise or distortion.
This feature cannot be accessed if a document is stored in memory.
• Both the sender and the receiver must have the ECM feature to
perform ECM communications.
• Communication time is longer when transmissions are affected
by interference.
To set the Error Correct-ECM default mode:
1. Press:
2. To enable ECM, press .
To disable ECM, press .
3. The menu selection screen redisplays. Press
Exit
or
Stop
to
return to the Standby Mode.
Note: ECM must be set to On when the 33.6K BPS Modem is in
your machine.
Menu
2.Off
Error correct-ECM
1.On
