Filter
Top Products
Installing the 9A656-04 Module
2-4
The Module Card DIP Switch
An eight position DIP switch is located on the module card as shown in
Figure 2-3. The functions of the switches are listed in Table 2-1.
!
CAUTION
Do not toggle Switch 8 unless you intend to reset the user configured passwords
to their factory default settings.
Do not toggle Switch 7 unless you intend to reset the user parameters to the
factory default settings. Refer to the
9A656-04 Configuration Guide
for
instructions on the parameters that may be configured by the user via
Local/Remote Management.
Table 2-1. Function of the DIP Switch
Switch Function Description
8
Clear
Password
When toggled, this switch clears user-entered
passwords stored in NVRAM, and restores the
default passwords. Once reset you can use the
defaults or enter new passwords.
7
Clear
NVRAM
The module uses NVRAM to store user
entered parameters such as IP addresses,
device name, etc. To reset these parameters to
the factory defaults, toggle this switch. Once
reset you can use the defaults or enter new
parameters which are stored in NVRAM when
the module is powered down, and remain
there until the switch is toggled again.
6
Force BootP
Download
Toggling this switch after pulling the board
out of the SmartSwitch 9500, clears download
information from NVRAM and forces image
files to be downloaded from the station
connected to the EPIM on the Environmental
Module configured to act as that modulesÕ
B
OOT
P server.
5 Reserved For Factory Use Only
4 Reserved For Factory Use Only
3 Reserved For Factory Use Only
2 Reserved For Factory Use Only
1 Reserved For Factory Use Only