Filter
Top Products
BASIC FUNCTIONS
BASIC OPERATION
29
Call Waiting is a system dependent feature. Please contact
your service provider for details.
BASIC OPERATION
BASIC FUNCTIONS
28
■
CALL WAITING
Notifies you of an incoming call when you are already on a call by
sounding a beep tone and displaying the caller’s phone number.
To answer another call while on the handset, press .
This places the first call on hold. To switch back to the
first caller, press again.
■
2 SEC/HARD PAUSE
Pauses are used for automated systems (i.e., voice mail, calling
cards). Insert a pause after a handset number then enter another
group of numbers. The second set of numbers is dialed
automatically after the pause. This feature is useful for dialing into
systems that require a code.
To insert a pause, enter a handset number then
press [MENU]. Select either a “2 Sec Pause”
(“T”) or a “Hard Pause” (“P”).
Press to dial or [SAVE] to store the
handset number.
Please refer to page 38 for more details about
storing a handset number.
NUMBER
Select
“2” or ”3”
ᕢ
ᕡ
■
ADJUSTING VOLUME
Adjust the volume of the ringer, key beep and speaker phone.
Select one of the following.
Adjust volume and press [SAVE] to save it.
ᕢ
ᕡ
To adjust volume in idle mode, press side volume key.
■
CALLER ID
Identifies callers by displaying their phone number.
If the caller’s name and number are already stored in
your contact list, they will both appear.
The caller ID information is stored in Call History.
•
Ring: Controls the ringer volume.
•
Receiver: Controls the receiver volume.
•
KeyPad: Controls the keypad volume.
•
Effects: Controls the effects volume.
•
Wake-up Call: Controls the wake-up call volume.
•
Alert: Controls the alert volume.
•
Power Up/Down: Controls the power up/down volume.
■
USING FLASHLIGHT
This function allows you to use the handset’s camera flash as a miniature
flashlight. To use this function, your handset must be in standby mode.
In standby mode, press and hold .