Filter
Top Products
8
Install plenum covers under deck pans.
The plenum covers are shipped loose in
the case and are installed between the
lower rear baffle and the fan plenum.
6
Seal joints along pipe chase seam with
the caulk provided.
Now that cases have been
positioned and leveled, you
may proceed to trim-out
case lineup. Trim parts have
been designed to be applied
easily with only a small
number of fasteners
required. Most external
parts are adjustable to
achieve almost invisible,
snug-fitting joints and a
high level of excellence in
fit and finish.
8
TRIM OUT
1
Tighten all joint bolts. Draw up tightly,
but do not over tighten.
2
Adjust polymer master bumper joints, if
required. First loosen bumper screws.
3
Slide bumper joint to the center of the
joint between the two cases. Use screw
driver in hole provided.
4
Slide master bumper left or right to
close seam as required. Bumper joint
neatly finishes any gap that may remain.
5
Close seam where bumper joins case
end. Bumper joint closes seam that
may develop if master bumper is moved
away from end to close case-to-case
joint seam.
COIL
PLENUM
DECK PAN
PLENUM
COVER
LOWER
REAR
BAFFLE
7
Apply acrylic tape over pipe chase seam.
Tape is found with the ship loose items
and acts as a watershed preventing
water from settling in case joint.
ACRYLIC
TAPE
PIPE
CHASE