Filter
Top Products
16
cFP-20xx Quick Start Guide
ni.com
D. Click
CChhaannnneell CCoonnffiigguurraattiioonn
to access the Channel Configuration dialog box, shown in the
figure at right.
Make your selections in this dialog box as follows:
1. Select the type of channel to show, then select the channel(s) that you want to change.
To select more than one channel, clear the
OOnnee cchhaannnneell aatt aa ttiimmee
checkbox.
2. Set the range and output values of the selected channel(s).
3. Set the deadband for data communication over the network. The deadband setting is a
percentage of the full-scale range.
4. Set attributes for selected channel(s) by selecting the attribute and entering the desired
value.
5. Send commands to the selected channel(s) by choosing a command and value and
clicking
SSeenndd
.
6. Repeat this procedure for each channel you want to configure.
7. Click
OOKK
, or click
AAppppllyy
to save the changes and continue to configure channels. When
you click
OOKK
or
AAppppllyy
, the changes are immediately sent to the device and saved in its
nonvolatile memory.
NNOOTTEE
Configuration options vary by module. The options listed here may not be
available for some modules.