Filter
Top Products
IInnssttaallll tthhee ccFFPP--2200
xxxx
CCoonnttrroolllleerr oonn tthhee BBaacckkppllaannee
A. Make sure that no power is connected to the controller or the backplane.
B. Make sure that the cFP-20
xx
controller is right side up with the NI logo at the top, and align
the captive screws on the controller with the holes on the backplane.
C. Seat the card edge at the back of the controller in the card-edge connector on the backplane.
D. Press the controller firmly to seat it on the backplane.
E. Using a number 2 Phillips screwdriver with a shank of at least 64 mm (2.5 in.) length, tighten
the captive screws to 1.1 N
⋅⋅
m (10 lb
⋅⋅
in.) of torque.
2
NATIONAL
INSTRUMENTS
5
cFP-20xx Quick Start Guide
©
National Instruments Corporation