Nokia 3500 Cell Phone User Manual


 
3. Open the card holder (2), and insert the memory card
into the card holder with the contact surface facing
inwards (3).
4. Close the card holder (4), and slide the card holder to
lock it (5).
5. Insert the battery, and attach the back cover to the
phone.
Charge the battery
Check the model number of any charger before use with
this device. This device is intended for use when supplied
with power from the AC-3 or AC-4 charger.
Warning: Use only batteries, chargers, and
enhancements approved by Nokia for use with this
particular model. The use of any other types may
invalidate any approval or warranty, and may be
dangerous.
For availability of approved enhancements, please check
with your dealer. When you disconnect the power cord of
any enhancement, grasp and pull the plug, not the cord.
1. Connect the charger to a wall socket.
2. Connect the lead from the
charger to the socket on
the bottom of your device.
If the battery is completely
discharged, it may take a few
minutes before the charging
indicator appears on the
display or before any calls can
be made.
The charging time depends on the charger used. Charging
a BL-4C battery with the AC-4 charger takes approximately
1 hour while the device is in the standby mode.
Antenna
Note: Your device may have internal and
external antennas. As with any radio
transmitting device, avoid touching the antenna
unnecessarily when the antenna is in use.
Contact with such an antenna affects the
communication quality, may cause the device to
operate at a higher power level than otherwise
needed and may reduce the battery life.
The picture shows the antenna area marked in grey.
Headset
Warning: Listen to music at a moderate level.
Continuous exposure to high volume may damage your
hearing.
Pay special attention to volume level if you connect any
other headsets to the device.
Warning: When you use the headset, your ability
to hear outside sounds may be affected. Do not use the
headset where it can endanger your safety.
Do not connect products that create an output signal as
this may cause damage to the device. Do not connect any
voltage source to the Nokia AV Connector.
11