Nokia 6102 Cell Phone User Manual


 
Get started
14 Copyright © 2005 Nokia
Insert the SIM card (5). Make sure that the SIM card is
properly inserted, and that the golden contact area on
the card is facing downwards. Close the SIM card holder
(6) and press it until it snaps into position.
Replace the battery (7). Observe
the battery contacts. Always use
original Nokia batteries. See
“Nokia battery authentication
guidelines,” p. 68.
Slide the back cover into its
place (8, 9).
Charge the battery
Warning: Use only batteries, chargers, and enhancements approved by
Nokia for use with this particular model. The use of any other types may
invalidate any approval or warranty, and may be dangerous.
Check the model number of any charger before use with this device. This device is
intended for use when supplied with power from an AC-3, AC-4, and DC-4 charger,
and from AC-1, ACP-7, ACP-12, and LCH-12 charger when used with the charger
adapter CA-44, which is available at your Nokia dealer or www.nokiausa.com
.
For availability of approved enhancements, please check with your dealer.
1. Connect the charger to a wall socket.
2. Connect the lead from the charger to the
socket on the bottom of your phone.
If the battery is completely discharged, it may take a
few minutes before the charging indicator appears
on the display or before any calls can be made.
The charging time depends on the charger and the battery used. For example,
charging a BL-4C battery with the AC-3 charger takes approximately 2 hours and
12 minutes while the phone is in the standby mode.
Switch the phone on and off
Press and hold the end key.
If the phone asks for a PIN or a UPIN code, enter the code (displayed as ****), and
select OK.