Filter
Top Products
Call functions
24
Make a voice dialing call
If an application is sending or receiving data using a packet data
connection, end the application before you use voice dialing in GSM. In
WCDMA it is possible to send voice and data simultaneously.
Voice commands are language-dependent. To set the language, see
Voice playback language in “Phone,” p. 71.
Note: Using voice tags may be difficult in a noisy environment or during
an emergency, so you should not rely solely upon voice dialing in all
circumstances.
1. In the standby mode, press and hold the right selection key. A short
tone is played, and Speak now is displayed.
If you are using a compatible headset with the headset key, press and
hold the headset key to start the voice dialing.
2. Say the voice command clearly. If the voice recognition is successful,
a list with matches is shown. The phone plays the voice command of
the match on the top of the list. After about 1.5 seconds, the phone
dials the number; or if the result is not the correct one, scroll to
another entry, and select to dial the entry.
Using voice commands to carry out a selected phone function is
similar to voice dialing. See Voice commands in “My shortcuts,” p. 62.
■ Answer or reject a voice call
To answer a call, press the call key. To answer the call by opening the
slide, see also Slide call handling in “Call,” p. 70.
To mute the ringing tone before you answer the call, select Silence.
To end the call or reject a call, press the end key.
Call waiting
During a call, to answer the waiting call, press the call key. The first call
is put on hold. To end the active call, press the end key.
To activate the Call waiting function, see “Call,” p. 70.