Filter
Top Products
20
Accessories guide
To charge the communicator battery with the desktop stand
1 Plug the Performance Travel Charger into the stand.
2 Place the communicator in the desktop stand connector end first.
3 Plug the charger into a mains outlet.
To charge a spare battery with the desktop stand
1 Plug the Performance Travel Charger into the stand.
2 Insert the battery in the second slot the golden contacts first. Push the
battery slightly backwards, see figure 11. Ensure that the battery clicks
into place.
3 Plug the charger into a mains outlet. Check that the light on the left of the
stand is on. The red light indicates charging, and the steady green light
indicates that the battery is charged.
4 To remove the battery, reverse the procedure shown in figure 11.
To connect to a PC
With the communicator in the desktop stand, you can connect to a PC with
the RS-232 adapter cable DLR-2.
1 Plug the adapter cable into the connector at the back of the stand.
2 Connect the other end of the cable to the PC.
Figure 11
Note: If the communicator is also
charging in the desk stand, the charging
of the spare battery will cease until the
battery in the communicator is charged.