Filter
Top Products
22
Accessories guide
To place the communicator in the holder
1 Close the cover of the communicator and turn the antenna to a closed
position.
2 Insert the communicator in the car kit holder connector end first, as shown
in figure 12.
3 In order not to damage the connectors, press the communicator down
gently until it is securely held by the locking mechanism.
Handset Kit
The optional Handset Kit HSU-1 is a simple handset with no display or keypad.
It provides privacy for conversation and comfort in a car environment while
your communicator is connected to the car antenna for better reception.
However, do not use the handset while in motion.
To make a call with the car kit
1 Key in the desired number with the keypad.
2 Press . For a private call, lift the handset if installed.
To answer a call
1 Press , or, if the handset is installed, lift the handset.
If you set the Automatic answer feature on in the Car profile, the
communicator will automatically answer incoming calls.
To switch from handset operation to handsfree operation
Press the Options selection key once and replace the handset in 5 seconds. If
you do not press Options before replacing the handset, the call will end.
To end a call
Press , or, if the handset is installed, replace the handset.
To connect to a computer
With the RS-232 adapter cable DLR-2 you can connect the communicator to
a laptop computer for fax modem use or PC Suite operation.
1 Close the device cover and place the communicator securely in the car kit
holder.
2 Insert the plug of the adapter cable into the connector of the holder. The
connector is located at the bottom of the holder.
Note: The car kit does not
include an antenna. Ask your car
kit dealer for available products.