Filter
Top Products
66
Storing touch tone strings
Touch tone strings can be used for sending and
receiving information with your phone. For example,
you can store your office voice mailbox number, along
with your password for easy access to your messages.
Store touch tone strings the same way you store
phone numbers (
see page 48
).
You can store a whole digit sequence in your phone
book and send it as touch tones for frequently-used
strings of numbers.
Sending a touch tone string
Make sure Menu 4 2 3 1 (
Settings
-
Phone settings
-
Touch tones
-
Manual touch tones
) is not set to
Off
.
1.
During a call, press
Options
2.
Scroll to
Touch tones
and press
OK
3.
Enter touch tone string or recall string from the
phone book and press
OK
Note: Use caution when sending confidential information over
the air when using DTMF tones in analogue mode.
Storing touch tone strings with phone numbers
1.
Enter the phone number (e.g. your office voice
mailbox)
2.
Press
∗∗∗
(p) or
∗∗∗∗
(w)
3.
Enter the touch tone string (e.g. voice mailbox
password)
4.
Store the number as you normally would
Note: See “Special Characters (for storing numbers)” on
page 35 for details on “p” and “w” characters.
When you dial this number, your phone first dials the
phone number, then waits (because of the “w” character)
for you to press
Send
. Your phone then sends your
password.
If you include a “p” character instead of a “w”, your
phone pauses for 2.5 seconds, then automatically
sends your password as touch tones.