storage, and distribution areas; chemical plants; or
where blasting operations are in progress. Areas with
a potentially explosive atmosphere are often, but not
always, clearly marked. They include areas where you
would be advised to turn off your vehicle engine,
below deck on boats, chemical transfer or storage
facilities and where the air contains chemicals or
particles such as grain, dust, or metal powders. You
should check with the manufacturers of vehicles
using liquefied petroleum gas (such as propane or
butane) to determine if this device can be safely used
in their vicinity.
Emergency calls
Important: This device operates using radio signals,
wireless networks, landline networks and user-
programmed functions. If your device supports voice
calls over the internet (internet calls), activate both
the internet calls and the cellular phone. The device
may attempt to make emergency calls over both the
cellular networks and through your internet call
provider if both are activated. Connections in all
conditions cannot be guaranteed. You should never
rely solely on any wireless device for essential
communications like medical emergencies.
To make an emergency call:
1 If the device is not on, switch it on. Check for
adequate signal strength. Depending on your
device, you may also need to complete the
following:
• Insert a SIM card if your device uses one.
• Remove certain call restrictions you have
activated in your device.
• Change your profile from Offline or Flight
profile to an active profile.
2 Press the end key as many times as needed to
clear the display and ready the device for calls.
3 Enter the official emergency number for your
present location. Emergency numbers vary by
location.
4Press the call key.
When making an emergency call, give all the
necessary information as accurately as possible. Your
wireless device may be the only means of
communication at the scene of an accident. Do not
end the call until given permission to do so.
Certification information (SAR)
This mobile device meets guidelines for exposure
to radio waves.
Your mobile device is a radio transmitter and receiver.
It is designed not to exceed the limits for exposure to
radio waves recommended by international
guidelines. These guidelines were developed by the
independent scientific organization ICNIRP and
include safety margins designed to assure the
protection of all persons, regardless of age and
health.
The exposure guidelines for mobile devices employ a
unit of measurement known as the Specific
Absorption Rate or SAR. The SAR limit stated in the
ICNIRP guidelines is 2.0 watts/kilogram (W/kg)
averaged over 10 grams of tissue. Tests for SAR are
conducted using standard operating positions with
the device transmitting at its highest certified power
level in all tested frequency bands. The actual SAR
level of an operating device can be below the
maximum value because the device is designed to use
only the power required to reach the network. That
amount changes depending on a number of factors
such as how close you are to a network base station.
Additional safety information 67
© 2010 Nokia. All rights reserved.