Filter
Top Products
EN 15
En
Open the Case
1 Slide and hold the slide lock towards the arrow direction (1) and turn the open/close dial counter
clockwise (2).
2 Turn the open/close dial to the position where it cannot be turned further.
3 Open the rear lid of the Case gently.
Attach the digital camera to the camera table
In order to load the camera into the Case, attach the camera table (located on the front-lid side of the
Case) to the digital camera.
CAUTION:
Do not exert too much force while turning the open/close dial. Doing so may damage the dial.
1 The eyecup and the hot shoe cover of the digital
camera can be stored in the camera table.
2 Attach the camera table to the tripod seat section on
the bottom of the digital camera. Use the camera’s
tripod screw hole for attaching.
3 The camera table has fixed up-down and front-rear
orientations. To ensure that it is properly attached,
refer to the illustration on the right.
Slide lock
1
2
Up
Down
Front
Rear
PT-E06_EN.Book Page 15 Thursday, February 26, 2009 5:04 PM