Filter
Top Products
EN 16
En
Insert the digital camera in the Case
1 Pull out the zoom dial and mode dial on the Case (pulling out the mode dial also pulls up the power
switch lever) so that they do not get in the way while loading the digital camera.
At this time, set the orientation of the power switch lever as shown below.
2 After attaching the camera table to the digital camera, slide the camera table into the Case’s camera
table-loading groove. Do not insert the camera table by force. Slide it in gently while checking that
the digital camera does not interfere with the internal parts of the Case.
3 Gently push the Case’s zoom dial and mode dial down and confirm that the zoom dial can smoothly
control zooming, the power switch lever can turn the digital camera ON/OFF, and that the mode dial
can control the mode dial of the camera.
PT-E06_EN.Book Page 16 Thursday, February 26, 2009 5:04 PM