Olympus E06 Carrying Case User Manual


 
EN 3
En
6 Jumping into the water with the Case in your pocket or in your hand, throwing the Case from a boat
or ship into the water, and other rough handling may cause water leakage. Please handle with
sufficient care, when handing it over from hand to hand etc.
7 If the camera on the inside should become wet because of water leakage etc., immediately wipe off
all moisture and confirm the operation.
8 Be careful not to apply excessive force to the port connector, TTL cable connector, zoom dial or tripod
seat.
9 Do not push the air vent valve from inside.
0 Please remove the O-ring when traveling by air. Otherwise air pressure may make it impossible to
open the Case.
a For safe use of the digital camera in this product, please read the “Instruction Manual” for the digital
camera carefully.
b When sealing this product, take sufficient care that no foreign matter gets caught at the O-ring and
the contact surfaces.
c The camera’s built-in flash cannot be used when the Case is combined with an external Olympus
flash. Also, the camera’s built-in flash cannot be popped up if the hot shoe cable is connected to the
camera’s hot shoe. If the built-in flash is forcibly popped up, the connected flash will not work properly
and the hot shoe cable may be disconnected from the camera’s hot shoe. In this case, the camera
may also be damaged.
d The camera’s built-in flash cannot be used when the camera is in the Case.
PT-E06_EN.Book Page 3 Thursday, February 26, 2009 5:04 PM