Filter
Top Products
45
Note:
End Calls Before relaunching the Voice Service voice recognition
software — When you use Voice Commands to make a call, you must end
that call before you can use other Voice Commands. (For more information,
refer to “Voice Service” on page 127.)
Use the Call command to dial any number stored in your Contacts list
by saying the name of the contact (Name Dialing). You can also use
Call to dial any telephone number, even numbers not stored in your
contact list, by speaking the individual digits in the number (Digit
Dialing).
Voice Dialing Tips:
•
Wait for the beep before speaking.
•
Speak clearly at a normal volume, as if you were talking to someone on the
phone.
•
When saying a name, say the first name then the last name.
Dialing a Name
To dial a name, do the following:
1. In Standby mode, tap Menu ➔ Voice Commands.
“Please say a command” is pronounced through the speaker.
2. Say, “Call”.
You are prompted to “Say the name or number of the person
you would like to call, or say voicemail or last number”.
3. Speak clearly and say the name of a person in your Contacts
list, first name followed by last name.