Samsung STSAM828CPWP Cell Phone User Manual


 
Understanding Your Phone 15
Turning Your Device On and Off
Turning Your Device On
Press and hold .
Once your device is on, it may display “Searching for Service.”
When your device finds a signal, it enters standby mode – the
device’s idle state. At this point, you are ready to begin making
and receiving calls.
If your device is unable to find a signal after 15 minutes of
searching, a Power Save feature is automatically activated. When
a signal is found, your device automatically returns to standby
mode.
In Power Save mode, your device searches for a signal
periodically without your intervention. You can also initiate a
search for service by pressing any key (when your device is
turned on).
Tip:
The Power Save feature conserves your battery power when you are in
an area where there is no signal.
Turning Your Device Off
1. Press and hold for two seconds until you see the
Phone options
menu.
2. Tap (
Power off
) and then tap
OK
to power off the
device.
Your screen remains blank while your device is off (unless the
battery is charging).
Battery and Charger
Warning!:
Use only Samsung-approved batteries and chargers with your
device. The failure to use a Samsung-approved battery and
charger may increase the risk that your device will overheat, catch
fire or explode, resulting in serious bodily injury, death or property
damage.
Battery Capacity
Your device is equipped with a Lithium Ion (Li-Ion) battery. It
allows you to recharge your battery before it is fully drained. The
battery provides up to 6.5 hours of continuous talk time.
At 3% of charge capacity, there are only a few minutes of talk
time left, the device sounds an audible alert, displays a critical
charge icon ( ), then turns off.
SCH-M828UM.book Page 15 Thursday, September 1, 2011 3:43 PM