Sanyo MM-5600 Cell Phone User Manual


 
Section 2K: Using Sprint PCS Ready Link 154
Receiving a Sprint PCS Ready Link Call
To receive a Sprint PCS Ready Link call:
1. Make sure your phone’s Sprint PCS Ready Link mode is enabled
(see “Setting Sprint PCS Ready Link Mode” on page 147).
2. When you receive a Sprint PCS Ready Link call from a contact,
“R-Link Call,” the contact’s name, and the Sprint PCS Ready Link
number appear on the display. (You do not need to take any
action to answer the call.)
When you receive a group call,“Group Call” and the
Sprint PCS Ready Link number appear.
If nobody takes the floor for 20 seconds, the call will be a
missed Ready Link call.
3. If the person placing the call has kept the floor (held the
Ready Link/Recorder button),you will see the contact name
and Sprint PCS Ready Link number along with “has floor.,” and
you will hear the caller speaking.
4. When the caller finishes speaking and releases ,you will
see “Floor is open.” on the display screen. Press and hold to
take the floor and reply to the caller. (You will see “You have floor.
and hear a tone confirming that you may speak.)
5. When the conversation is finished, press .
Tip:You can also receive a Sprint PCS Ready Link call with the flip closed. Press
and hold to take the floor when the floor is open.
Note:You can change the volume and the speakerphone setting while a
Sprint PCS Ready Link call is activated.
Volume:Adjust the voice volume by using
the Side Volume key or by pressing the navigation key up or down except when
you are pressing and holding
.Speaker:Switch the speakerphone on or off
by pressing .