Sanyo PM-8200 Cell Phone User Manual


 
Using Your Phone’s Battery and Charger
Battery Capacity
Your PCS Vision Phone is equipped with a Lithium Ion (LiIon)battery.
It allows you to recharge your battery before it is fully drained.
The battery provides approximately 3.0 hours of continuous digital
talk time(1.7 hours in analog)or approximately 288 hours of
continuous digital standby time(17 hours in analog).
When the battery reaches 5% of its capacity, the low battery icon
appears. When there are approximately two minutes of talk time left,
the phone sounds an audible alert and then powers down.
Note:Long backlight settings, searching for service, vibrate mode, PCS Ready
Link mode, and browser use affect the battery’s talk and standby times.
Tip:Be sure to watch your phone’s battery level indicator and charge the battery
before it runs out of power.
Installingthe Battery
To install the LiIon battery:
1. Place the battery into the space beneath
the antenna with the metal contacts at
the bottom,facing downward.
2. Gently press down until it’s in place and
the battery release latch snaps.
Removingthe Battery
To remove your battery:
1. Make sure the power is off so that you
don’t lose any stored numbers or
messages.
2. Push the battery release latch up and
hold the battery.
3. Pull the battery up and out at a 45-degree
angle.
Section 2A: Your PCS Vision Phone – The Basics 16