Sanyo VL-2300 Cell Phone User Manual


 
168 Section 2J: Using Sprint PCS Ready Link
Receiving a Sprint PCS Ready Link Call
To receive a Sprint PCS Ready Link call:
1. Make sure your phone’s Sprint PCS Ready Link mode is
enabled (see “Setting Sprint PCS Ready Link Mode”on
page 160).
2. When you receive a Sprint PCS Ready Link call from a
contact, “R-Link Call,”the contact’s name, and the
Sprint PCS Ready Link number appear on the display.
(You do not need to take any action to answer the call.)
When you receive a group call, “Group Call”and the
Sprint PCS Ready Link number appear.
If nobody takes the floor for 20 seconds, the call will
be a missed Ready Link call.
3. If the person placing the call has kept the floor (held the
Ready Link/Memo button), you will see the contact
name and Sprint PCS Ready Link number along with “has
floor.,”and you will hear the caller speaking.
4. When the caller finishes speaking and releases , you
will see “Floor is open.”on the display screen. Press and
hold to take the floor and reply to the caller. (You will
see “You have floor.”and hear a tone confirming that you
may speak.)
5. When the conversation is finished, press .
Tip:You can also receive a Sprint PCS Ready Link call with the flip closed.
Press and hold to take the floor when the floor is open.
Note:You can change the volume and the speakerphone setting while a
Sprint PCS Ready Link call is activated. Volume:Adjust the voice volume by
using the Side Up/Down key or by pressing the navigation key up or down
except when you are pressing and holding .Speaker:Switch the
speakerphone on or off by pressing .