Sony Ericsson P908 Cell Phone User Manual


 
12 Getting to know your P908
This is the Internet version of the user’s guide. © Print only for private use.
Charging the battery
When the battery needs to be charged, a beep is heard. The
indicator light (on the top of your P908) flashes red and a
battery low message appears on the screen.
The battery can be charged whenever you want. The P908
performance is not affected. However, using your P908 while
charging increases the charging time.
To charge the battery
The P908 can be charged either when it is switched on or off.
1. Make sure the battery is inserted in your P908 and the cover
is closed.
2. Connect the charger to
the P908 at the base of
the phone by the flash
symbol. The charger
plug flash symbol must
face upwards.
3. Connect the charger to
the mains.
Charging is indicated by the battery meter on the screen pulsing
continuously, and the indicator at the top of the P908 showing a
steady red light (or green, if the P908 is switched on).
See also ‘Battery Use and Care’ on page 183.
Tip You can also use other battery chargers that have been
supplied with other Sony Ericsson mobile phones using the same
connector plug, for example, T68i or T300.
Note When the battery is completely discharged, or new, it may
take up to 30 minutes before the battery charging icon appears
on the screen.
4. Wait approximately 4 hours or until the battery meter on the
screen is full and the indicator on the top of the P908 shows a
steady green light.
5. Remove the charger by tilting
the plug upwards.
Care instructions
Your P908 is a highly sophisticated electronic device. To get the
most out of it, please make sure that you follow this advice:
Keep the P908 in its protective bag when not using it.
Use a commercial glass screen cleaner sprayed on a cloth,
when you clean the screen.
Use only the stylus provided to tap the screen.