Filter
Top Products
SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
4.2 User-defined Preferences
The following user-defined preferences are also covered in the NetLink e340/i640
Wireless Telephone user guide. The system administrator can refer to this list for more
information about customizing Wireless Telephone settings.
To configure the following options, the Wireless Telephone must acquire the system (no
error message may display) and be at the extension display. This is the standby state.
While in the standby state, press and hold
FCN briefly to open the user options menu.
Use the following keys to display and select options:
Up/Down buttons: display previous/next menu item.
Select
button: selects the menu item or option.
OK softkey selects the menu item or option.
Save softkey: saves the entry.
Bksp softkey: backspaces to allow editing of entry.
Cncl softkey: cancels edit and returns to previous menu level.
Up softkey: returns to previous menu level.
Exit softkey: exits the menu (at the top level).
End Call key: exits to standby state (from any level)
Standby menu item 2
nd
Level 3
rd
Level
Ring Type Telephone ring
Normal Ring
Vibrate Ring
Vib/Norm Ring
Auxiliary ring 1 “
Auxiliary ring 2 “
Noise Mode
Normal
High
Severe
Alias IP Addr
Current IP Addr
Extension
Mitel options
Current RTC IP
Current TCP Port
Current RTP Port
Push-to-talk Channel 1-8
Enable/Disable
Enable
Disable
Ring Type
Select Ring Type then Telephone Ring to change the standard ring used
for normal operation. From the
Telephone Ring menu, select either
Normal Ring (an audible alert), Vibrate Ring or Vib/Norm Ring (vibrate
for five seconds and then audible alert for subsequent rings). The
Auxiliary Ring modes are reserved for future use. The ring type currently
in use displays with an asterisk (*).
PN: 72-1084-02-D.doc Page 23